The touchscreen operates well, using gestures similar to those of a tablet or touchscreen PC, which allows you to pinch, swipe, slide and tap your way through the exam. The A1 adjustment had very little effect I found that IC901 (TDA6108JF) on the tube base was faulty, pin 7 (blue o/p) and pin 8 (green o/p) both read s/c to ground. You may have to switch the view (upper left) to see it as it’s shown below. There was a very small crack in the solder at RH23, this is a 2K4 surface mounted resistor located at the back of the tube base. Only one section of this double pole switch is used.
Replace C622 (100uF) and C631 (100uF) (Valter) Goodmans TV Model: 1410 (TX805 Chassis) Dead One of the three series connected 68Kohms resistors was open-circuit. RP44 is rated at only 0.25w. It hides beneath two large green power resistors. Bang was 330pF cap 2540 across PSU MOSFET exploding, suspect went s/c. Diodes 6513 & 6511 cracked and s/c. Replaced C2540. Could not get diode 1N5062/BYW55 rep, so replaced all 4 diodes with BY399. PSU MOSFET removed and checked,ok. Adjust the audio head position (screws marked A and T) (Anonymous) Bluesky TV Model: TDX-70 (11AK19 Chassis) HT low / missing Q608 (BU2508) dead (short-circuited). Needed replacement.
TOSHIBA1. Выключите телевизор и установите модуль условного доступа. This was found to be leaky, It’s value is 47nF. Also resistor 3442 (3.9K) was o/c (Sparky) Lg TV Model: CI29H40 (PC8KA Chassis) There was a bright white screen with flyback lines on this set. Etpiv) Sony TV Model: KV20TR22 Intermittent reception on VHF / UHF Resolder tuner especially the around the tuner I.C (Engr. Bob, you can reset the printer settings to reverse the order of the print by following the instructions below. After trying 4 times to come up it goes to error standby with Led blinking very fast. Bob asks: I have an HP printer installed on my XP computer and it prints the last page first, the next to last page next, and so on.