You can assign different bandwidth levels and passwords and instruct users to connect to the specific virtual network, it will appear to wireless clients as a different SSID or a different device. Can damage the card if transmit power is set above rated value of the card for used rate manual-table — define transmit power for each rate separately. Class — If present, value of this attribute is saved and included in Accounting-Request messages.Caching Caching of RADIUS MAC authentication was added to support RADIUS authentication for clients that require from the access point very quick response to the association request. Property Description channel-time (; Default: 200ms) file-limit (integer [10..4294967295]; Default: 10) Allocated file size in bytes which will be used to store captured data. The users transmit in rapid succession, one after the other, each using his own time slot.
Example of scan command for one round: /interface wireless scan wlan1 rounds=1 ‘save-file’ option allows to do scripted/scheduled scans and save the results in file for future analysis. Since WPA authentication and key exchange is not symmetrical, one of the access points will act as a client for the purpose of establishing secure connection. Access point has to get corresponding value either from private-algo property of access-list, or from Mikrotik-Wireless-Enc-Algo attribute in RADIUS Access-Accept MAC authentication response. This mode should only be used in controlled environments, or if you have a special permission to use it in your region. Additionally, access point will remember authentication result, and if during this time client reconnects, it will be authorized immediately, without repeating EAP authentication.
Station will not use private key to decrypt broadcast frames.Management frame protection Used for: Deauthentication attack prevention, MAC address cloning issue. Wireless interface must have support for hardware compression. Find and connect to acceptable AP. station-wds — Same as station, but create WDS link with AP, using proprietary extension. AP configuration has to allow WDS links with this device. Access List Sub-menu: /interface wireless access-list Access list is used by access point to restrict allowed connections from other devices, and to control connection parameters. Such dynamic WDS entries are removed automatically after the connection with the other AP is lost.-mesh modes use different (better) method for establishing link between AP, that is not compatible with APs in non-mesh mode. Station private key replaces key 0 for unicast frames.